Tap Water Quality in Willow Banks, SA
Postcode 5253 · Supplied by SA Water via Murray Bridge
Quality Score
About Willow Banks
Willow Banks is a suburb in South Australia, Australia (postcode 5253). It falls within the SA Water area. Neighbouring suburbs include Avoca Dell, Brinkley, Burdett, Chapman Bore.
Tap water in Willow Banks is supplied by SA Water. The suburb receives water via the Murray Bridge supply zone.
Water quality summary
Based on 2025 water quality reports, Willow Banks achieves a WaterScore of 8.9 out of 10, rated excellent overall. Water hardness measures 90 mg/L, classified as moderately hard. This may cause light mineral deposits on fixtures over time. The pH level is 0.05, which is outside the ADWG guideline range of 6.5–8.5. The water is fluoridated at 0.8 mg/L, within the recommended range of 0.6–1.1 mg/L for dental health, well under the ADWG maximum of 1.5 mg/L. Chlorine, used for disinfection, measures 2.2 mg/L — well within the ADWG guideline of 5 mg/L. Some residents may notice a slight taste, which can be reduced by refrigerating water or using a carbon filter. Total dissolved solids (TDS) measure 285 mg/L, considered low against the ADWG guideline of 600 mg/L. Turbidity is 0.11 NTU, indicating clear water, within the ADWG guideline of 5 NTU. E. coli was not detected in testing, meeting the ADWG standard for microbiological safety.
Compare with nearby suburbs: Avoca Dell , Brinkley , Burdett
Recommended filters for Willow Banks
Products matched to your water profile
BRITA
Marella 2.4L Fridge Water Filter Jug (Maxtra+)
4.7 · 16,095 ratings on Amazon
Ideal for Willow Banks — removes chlorine taste and odour.
Waterdrop
TSA Under-Sink Filter (Fluoride + PFAS)
4.4 · 2,237 ratings on Amazon
A reliable tsa under-sink filter (fluoride + pfas) suitable for Willow Banks's water profile.
Purewell
8.5L Stainless Steel Gravity System
4.4 · 1,137 ratings on Amazon
Ideal for Willow Banks — removes chlorine taste and odour.
Comparison
How Willow Banks compares
Compared to South Australia and national averages
| Metric | Willow Banks | SA Avg | National Avg |
|---|---|---|---|
| Hardness | 90 mg/L | 119.3 mg/L | 85.1 mg/L |
| pH | 0.05 | 3.2 | 8.4 |
| Fluoride | 0.8 mg/L | 0.5 mg/L | 0.7 mg/L |
| Chlorine | 2.2 mg/L | — | — |
| Turbidity | 0.11 NTU | 0.1 NTU | 0.4 NTU |
| TDS | 285 mg/L | 341.5 mg/L | 275.7 mg/L |
Full Results
Detailed water quality data
All values compared against Australian Drinking Water Guidelines (ADWG)
| Parameter | Value | Unit | ADWG Guideline | Status |
|---|---|---|---|---|
| Alkalinity | 64 | mg/L | No limit | Measured |
| Aluminium | 0.023 | mg/L | < 0.2 | Good |
| Calcium | 17.7 | mg/L | No limit | Measured |
| Chloride | 80 | mg/L | < 250 | Good |
| Free Chlorine | 2.2 | mg/L | < 5 | Good |
| Total Chlorine | 2.3 | mg/L | < 5 | Good |
| Colour | 1 | HU | < 15 | Good |
| Copper | 0.0205 | mg/L | < 2 | Good |
| E. coli | 0 | cfu/100mL | < 0 | Compliant |
| Fluoride | 0.8 | mg/L | < 1.5 | Good |
| Hardness | 90 | PPM or mg/L | < 200 | Good |
| Iron | 0.0051 | mg/L | < 0.3 | Good |
| Lead | 0.0002 | mg/L | < 0.01 | Good |
| Magnesium | 11.2 | mg/L | No limit | Measured |
| Manganese | 0.0023 | mg/L | < 0.1 | Good |
| Nitrate | 0.98 | mg/L | < 50 | Good |
| pH | 0.05 | µg/L | 6.5 – 8.5 | Outside range |
| Sodium | 59.1 | mg/L | < 180 | Good |
| Sulfate | 45 | mg/L | < 500 | Good |
| Total Dissolved Solids | 285 | mg/L | < 600 | Good |
| Turbidity | 0.11 | NTU | < 5 | Good |
Safety
Safety assessment
Of 21 parameters tested, most fall within Australian Drinking Water Guidelines with 1 exception: pH at 0.05 µg/L. E. coli was not detected, meeting the ADWG standard for microbiological safety.
Based on comparison with Australian Drinking Water Guidelines (ADWG)
Explained
What these numbers mean
Moderately hard (90 mg/L)
Water Hardness
Your water is moderately hard. You may notice light limescale deposits on kettle elements and taps over time. Soap lathers reasonably well, though slightly more product may be needed. Skin and hair are generally unaffected, and appliance lifespan should not be significantly reduced at this level.
Outside Range
pH Level
pH of 0.05 is outside the ideal range of 6.5–8.5. The ADWG recommends pH between 6.5 and 8.5 for drinking water.
Fluoridated
Fluoride
Fluoride at 0.8 mg/L. Within the recommended 0.6–1.1 mg/L range for dental health.
Chlorine
Disinfection
Chlorine measured at 2.2 mg/L, well within the ADWG guideline of 5 mg/L. Used for disinfection to keep water safe. May affect taste slightly — refrigerating water or using a carbon filter can help.
Learn more about these measurements in our water quality glossary — including Hardness , pH , Fluoride , and ADWG guidelines .
Advice
Practical tips for residents
Reduce Chlorine Taste
Willow Banks's chlorine level is 2.2 mg/L. An activated carbon jug filter or benchtop unit can noticeably reduce chlorine taste and odour from tap water.
Soft Water Advantage
Willow Banks's water is moderately hard at 90 mg/L. You can use less soap and detergent, as it lathers easily with softer water.
Fluoride in Your Water
Fluoride measures 0.8 mg/L in Willow Banks. Australian guidelines allow up to 1.5 mg/L. This is added by utilities to support dental health in the community.
Slightly Acidic Water
pH measures 0.05 in Willow Banks, which is slightly acidic. Running the tap for 30 seconds before drinking can flush any metals that dissolve more readily in acidic water.
Get water quality alerts
We'll email you when Willow Banks's water data is updated.
FAQ
Frequently asked questions
Is tap water safe to drink in Willow Banks?
How hard is the water in Willow Banks?
What water utility supplies Willow Banks?
Does Willow Banks water have fluoride?
What is the water quality score for Willow Banks?
Supplier
Water utility
- Utility
- SA Water
- Supply Zone
- Murray Bridge
- Data Source
- SA Water — water quality performance results november 2025
Nearby
Nearby suburbs
Same water utility, similar water quality
Similar Quality
Suburbs with similar water quality
Suburbs scoring between 7.9 and 9.9
Utility reports average the grid — not your home
Willow Banks's water meets ADWG standards at the source, but old pipes, roof tanks, and ageing plumbing can add lead, copper or bacteria before the water reaches your tap. These won't show up in your utility report.
Check your own tap before buying a filter or assuming the suburb average matches your home.
Tetra
EasyStrips 6-in-1 Water Test (100 strips)
4.6 · 8,650 ratings on Amazon
Tests 6 parameters in 60 seconds: hardness, chlorine, pH, nitrate, nitrite, alkalinity. Cheapest way to verify your utility data.
Test my tap →Sponsored Amazon link. Check Amazon for current price and availability.
Heavy Metals
Drinking Water Test Kit (Lead, Copper, Iron, Mercury)
4.2 · 250 ratings on Amazon
20 tests. Detects lead, copper, iron, mercury — the things utility reports miss. Mobile-app results, EPA-standard thresholds.
Check metals kit →Sponsored Amazon link. Check Amazon for current price and availability.
Guides for Adelaide and SA
In-depth articles on the water supply that serves Willow Banks
Related
Explore more
Related pages for Willow Banks, SA
Is tap water safe?
Safety assessment
Water hardness
90 mg/L
Best water filter
Filter recommendations
South Australia water quality
State coverage
SA Water
Water utility
Compare with Avoca Dell
Willow Banks vs Avoca Dell
Compare with Brinkley
Willow Banks vs Brinkley
Compare with Burdett
Willow Banks vs Burdett
Disclaimer: The information on this page is for general informational purposes only and does not constitute medical advice, health recommendations, or professional guidance. Water quality data is sourced from SA Water (2025 report) and reflects conditions at the time of utility testing — it may not reflect real-time water quality at your tap. Actual water quality can vary due to local plumbing, seasonal changes, and distance from the treatment plant. For specific health concerns, consult a qualified health professional. For the most current water quality information, contact your local water utility directly. See our Terms of Use.